Made of aluminum alloy anticorodal AC100, anodized, is inserted into existing fixed rod holders on the boat, no additional hole on the hull.
There are no welds, obtained from a solid bar for maximum strength.
As shown in the figures below, it allows two rotations, a rotation around its axis of 150 ° friction, the clutch may be adjusted by inserting a wrench 13mm inferiorly.
This prevents friction in fishing drifting in rough seas in rollio- boat pitching, reeds sun wheel, but still allows the alignment of the rod to the line in the event of a strike.
New version, with bush hole 40,5 mm over the entire length of scratch-resistant, available either as a replacement to the holders have already been sold in the past.
Used in drifting, big-game, thanks to the rotation of 150 degrees, the barrel is oriented in the direction of the line even if the boat changes direction of leeway. This arrangement causes the wire to flow centrally to the pulley dell'apicale in subsequent escape all'abboccata, avoiding breakage and chafing of the wire side.
With the vertical rotation, which ends in two positions to the stop, it becomes divergent as in trolling with lures or live.portacanne da barca, divergente persca a traina, porta canne da barca
All couplings are on anti-friction nylon bushings to ensure the rotation even under a heavy load.
It also allows the pumping of large fish directly from the fishing rod holders (just remove it from the cruise, rotate 180 degrees and reinsert the cruise) without having to wear a seat belt, and therefore reducing the risk of dangerous falls backwards accidental unhooking due to a failure or of the line.
Comfortable when used as divergent in trolling, keeps the reeds well wide side avoiding any unnecessary bumps out of the water of the artificial. The upward rotation it is especially easy to insert and remove the barrel, as it does not have to lean out from the sides for this operation, rotate vertically and remove the barrel, especially on days with "swell"
Due to the rotation of 150 °, and 90 ° 4 notches at the base, can be mounted either on the left or right side of the walls.
The screws are stainless steel, being of small size, diameter 4 cm. and total length of 58 centimeters, it is easy stowage.
Portacanne da barca, divergente traina, portacanne da barca per big game, divergente per la pesca a traina dalla barca
TEST di resistenza
A great demonstration of the strength of our aluminum fishing rod holders we made this TEST:
A steel bar to simulate the fishing rod 2 meters long, to which we have tied a weight of 22 kg, yielding NO! Even under such a load, rotates around its axis, thanks to the antifriction bushings mounted.
starlight, nautica accessori, canne da pesca, produzione accessori pesca, pesca a fondo accessori pesca, mulinello pesca, mulinello shimano, portacanne, surfcasting, pesca in mare, surf casting, portacanne da barca, divergenti canne traina, canne big game, portacanne drifting, segnalatori di abboccate, abboccatore, bobina rapida, fast reel
divergente traina, portacanne da barca per big game, divergente per la pesca a traina dalla barca